Common Mechanical Seal Cooling And Flushing Methods
The mechanical seal generates a large amount of frictional heat due to the friction of the end face, which increases the temperature of the friction pair ring. At the same time, if the sealing medium itself is hot, it will make the friction pair end face always operate at a very high temperature, in this case, if no flushing cooling measures are taken, it will make:
(1) Dry friction occurs due to evaporation of the liquid film between the end faces;
(2) The auxiliary sealing ring made of rubber and plastic materials will age, crack and even fail;
(3) Accelerate the corrosive effect of the sealing medium on the mechanical seal parts;
(4) Dynamic and static ring deformation;
(5) Increased wear of the end face;
(6) The end face leakage is serious.
From this point of view, the washing oil and cooling water for mechanical seals are to reduce the temperature during friction, ensure that there is a complete liquid film between the friction surfaces, reduce friction loss, reduce power consumption, and ensure that the liquid film is not destroyed due to high temperature vaporization. Therefore, the flushing and cooling measures of the mechanical seal are an indispensable and important link to ensure that the mechanical seal has good sealing performance and long service life.

