Mechanical Seal Assembly Technology Dimensional Check
1) Measure the size of the sealing surface of the dynamic and static ring. The data is used to verify the radial width of the dynamic and static ring, when different friction materials are selected, the radial width of the friction surface of the hard material should be 1~3mm larger than the soft, otherwise it is easy to cause the angularity of the end face of the hard material to be embedded in the end face of the soft material.
2) Check the gap between the dynamic and static ring and the shaft or shaft sleeve, the inner diameter of the static ring is generally 1~2mm larger than the shaft diameter, for the moving ring, in order to ensure floating, the inner diameter is 0.5~1mm larger than the shaft diameter to compensate for the vibration and deflection of the shaft, but the gap should not be too large, otherwise the moving ring sealing ring will be stuck and cause damage to the mechanical seal function.
3) Check the tightness of the mechanical seal. The mechanical seal tightness we usually talk about is the specific pressure of the end face, the specific pressure of the end face is appropriate, too large, will make the friction surface of the mechanical seal heat, accelerate the wear of the end face, and increase the friction power; Too small, easy to leak. The specific pressure of the end face is determined at the time of mechanical seal design, and we can only determine it by measuring the mechanical seal tightness when assembling. The usual measurement method is to measure the vertical distance from the installed static ring end face to the gland end face, and then measure the vertical distance from the moving ring end face to the gland end face, and the difference between the two is the tightness of the mechanical seal.
4) Measure whether the length of the compensation spring has changed. Changes in spring performance will directly affect the specific pressure of the mechanical seal end face. Under normal circumstances, the length of the spring will be shortened after a long period of operation, and the mechanical seal of the compensation spring on the moving ring will be deformed due to centrifugal force.
5) Measure the length of the static ring anti-rotation pin and the depth of the pin hole to prevent the static ring from being too long and the static ring cannot be assembled in place. This situation can damage the mechanical seal.

